The CHLK™ Belt Kit is a revolutionary approach to the modern battle belt – able to act as a low profile pistol belt or a full capacity MOLLE belt kit. CHLK - short for "Combat Helo Load Rated Kit" - was designed and built around the needs of the helicopter assaulters.  They needed a belt kit that was super low profile with fewer snag liabilities and load rated to be able to 'clip in' and provide life saving tethering to the aircraft. 

The Belt Kit starts with an inner belt that is worn weaving through your pant loops and is reversible to be pattern matched and can be worn as a standalone pistol belt. The outer belt is fully MOLLE compatible with MOLLEminus™ technology using slots instead of traditional webbing. The outer belt securely attaches to the inner belt with a hook and loop interface along with a load rated COBRA™ buckle. Two external tether points – one on the front and one on the rear – allow the user to clip into a safety line when needed. The Lightweight MOLLEminus Belt is produced with a curve very similar to a worn leather belt for greater comfort and to eliminate unnatural ‘ride up’ with a flat produced war belt. Also visible is the numerous holes for maximum ventilation and prevent hot spots in hot or humid environments for all day comfort.

The CHLK Belt Kit was designed for the air assaulter with a life saving load rating with two clip points - front and rear - to tether into a helo or other anchoring point.  

HOW TO GET YOUR CORRECT BELT SIZE

1. Put on your duty pants or equivalent
2. Take your pants belt and wrap it around your waist where your belt loops are
3. Guide the tail of the belt over the tip of the buckle and mark the spot with your finger or a piece of tape, where the belt meets the buckle at its tightest point
4. Lay your belt on a table and measure with a tape measure from the tip of the buckle to the marked spot
5. Find you’re the range of your specific measurement and then order the size to the right of that.

When in doubt, go up one size. For optimal stability, the ends of the CHLK Belt need to overlap and secure to each other contrast to other MOLLE belts where you would want it smaller.